Home > News > Content
Leveling Method For Band Saw Blade
- May 07, 2018 -

The degree of horizontality of the saw blade of the band saw machine, that is, the flatness of the surface of the saw blade. The level of the saw blade has a great relationship with the quality of the sawing machine. Therefore, trimming the horizontality of the saw blade is one of the important technical aspects.


Place the saw blade flat on the sawing platform and press the ends of the blade against it so that it does not warp upwards. Then, the flat card (straight ruler) is inclined perpendicular or slightly to the plane of the saw blade, tightly stuck on the plane of the saw blade, and the card board is gently moved back and forth along the longitudinal, lateral and oblique directions of the saw blade, while moving, carefully Observe the gap between the plate and the surface of the saw blade to find out its bulge and depression.


When checking the level of the saw blade, pay attention to the level of the platform. Because of the relatively thin saw blade, even though the saw blade is in line with the flat surface, the flatness of the saw blade is difficult to check out due to unevenness of the platform. Therefore, it was found that the platform must be trimmed in a timely manner where there is unevenness.

  

The inspection of the level of the saw blade needs to be carried out for a period of time. After the front inspection, the saw blade is reversed and the back side is inspected while being checked.


Copyright © Jinan North Jinfeng Sawing Machine Co.,Ltd. All Rights Reserved.