Home > News > Content
How To Install And Debug Horizontal Band Sawing Machine
- Nov 17, 2018 -

1. The hydraulic oil on the sawing machine should be sufficient, and the sliding and rotating parts should be covered with a layer of oil.

2. Install band saw blade, and adjust the tension device of the horizontal saw machine (turning the left handle of the saw frame) to make the band saw blade tighten up to a suitable degree. At the same time, the contact of the travel switch is adjusted to meet the iron barrier and is in the open state.

3. Add enough cooling fluid to the cooling water tank of horizontal sawing machine.

4. After doing the above preparations, connect the power supply, the grounding must be standard and reliable, turn on the power switch (in the electrical control box), start the test running, according to the sign indicated on the rotation correction wiring, while listening to whether its sound is normal.

5. Check the horizontal sawing machine lifting and lowering cylinder device, check whether the saw frame lifting and falling is reliable and flexible.

6. Check clamping and loosening cylinder device of horizontal sawing machine, check whether clamping is reliable and loosening is flexible.

7. Adjust the speed control switch of horizontal sawing machine, adjust it to first gear (low speed) operation, then turn to second gear (high speed) operation, repeated experiments three times.

8. When the power switch of the main motor of the horizontal sawing machine is turned on, the water pump starts at the same time, and the cooling system runs normally. Adjust the valve and check whether the coolant is smooth.

9. After doing the above preparations, load the material, clamp and lock the horizontal sawing machine for trial sawing.


Copyright © Jinan North Jinfeng Sawing Machine Co.,Ltd. All Rights Reserved.