Jinan North Jinfeng Sawing Machine Co., Ltd. is a well-known manufacturer specializing in producing bimetal band saw blades. It produces various types of LEPP band saw blades, BLG band saw blades and SLD band saw blades, which are durable, with good sawing effect and high technology content.
Bimetal band saw blade is the biggest consumable material in the use of band saw machine. If the device is not properly used, it will shorten the service life of band saw blade. What aspects should be paid attention to when using band saw blade device? Notice the following points, which can extend the service life of band saw blade:
1. Before installation, check the direction of saw tooth to make sure that the sawing direction is the same as the rotating side of the band sawing machine.
2. Check whether the number of teeth and the type of teeth of the saw blade are consistent with the material and scale of the material being cut.
3. Adjusting the tension of band saw blade to be moderate, too tight will simply break the blade, too loose will break the blade and cause oblique .
4. Adjust the concentration of the cutting fluid according to cutting material, the carbon steel is thinning and the stainless steel is concentrated. And replace regularly.
5. All new saw blades should be run in before cutting. During the running-in period (15-20 minutes), the feed pressure is reduced to 1/3-1/2 of the recommended value, and then the optimal cutting feed force is increased.
6. When changing the material, raise the saw blade to a certain height to avoid breaking the saw tooth.
Related Industry Knowledge
- Belt sawing machine
- Introduction of a sawing machine
- Metal cutting machine
- Principle of metal cutting machine
- Working principle of metal cutting machine
- Angle cutting machine
- Application range of angle cutting machine
- Horizontal band saw
- Band saw
- Wear with saw blade
- How can we reduce the cost of using biemtal ban...
- The premature of passivation saw tooth